AJINOMOTO ホンダ NSR 250 '90を製作しています
AJINOMOTO Honda NSR 250 '90 is being produced
マフラーの合わせ目処理
Muffler joint treatment
ある程度は出来たと思いますが
サフを吹かないと判らないですよね
それと溶接跡を削り落とした方が綺麗に処理が出来るのですが………
後で溶接跡を再現も綺麗にする自信も有りませんので………
スルーですかね(^_^;)))
I think that it was possible to some extent
I do not know without blowing Safu
And those who scrape the welding traces can process cleanly .........
I do not have confidence to clean up the welding traces later .........
Is it thru? (^ _ ^;)))
マフラーの出口
1.5ミリのピンバイスで穴を少し開けてます
白では判りにくいですね
Exit the muffler
I opened a hole a little with pin milling of 1.5 mm
It is difficult to understand in white
ラッカーパテも1週間以上放置してるので
削っていきます
削れましたがサフを吹いたらガックリかな?(^_^;)))
Although it was able to be scraped, is it bad if you blow SUFF? (^ _ ^;)))
こちらも再度削らねば
We have to cut it again
ホイールのパーティングラインも目立ちますので処理してます