レベルのポルシェ カレラ RS3.0を製作しています
We are producing level Porsche Carrera RS 3.0
付けたプラ板を削り
これからサフを吹いてチェックと思ったのですが………
すぐ上に箱絵が有りますよね
フロントバンパーを見比べると………
箱絵の方は中央部が少し丸みが有るような
キットの方は中央部がまっ平ら………
言い出せばキリは有りませんよね
バンパー下部のメッシュも……抜けてませんからね………(^_^;)))
Sharpen the attached plate
From now on I thought that checking by blowing SUFF .........
There is a box painting just above
Compared to the front bumper .........
The box picture has a slightly rounded center part
The central part of the kit is flat and flat .........
If you say it, you do not have a gimmick
The mesh at the bottom of the bumper is also ... ... I can not get out ... ... ... (^ _ ^;)))
メッシュ部分を抜く事にしました(^_^;)))
I decided to pull out the mesh part (^ _ ^;)))
以前シルエイティ(かなり前ですが)を作った時にお湯丸で型を取りパテでラジエターの複製をしたのが有ったので
I used to make molds with hot water circle when I made a previous SILAITY (pretty long ago), because there was a copy of the radiator with putty
仮に合わせてみて
Try to tentatively
シャシーの方に当たったりも無く
I never hit the chassis
使う事にしました
I decided to use it