フジミ 1/24 フェラーリ F-40 TOTIPを製作しています
ですがTOTIPでは製作しません
成型色を生かして製作予定です
We are manufacturing Fujimi 1/24 Ferrari F-40 TOTIP
But I do not produce in TOTIP
It is planned to make use of the molding color
フロントのステアリング回りの
よく見るとトーインがイン過ぎるんですよね
Around the front steering wheel
If you look closely, the toe-in is too in
タイロッドと言いますか……
ステアリングギヤボックスと言いますか(ラックアンドピニオンと言いますか)……
少し短いので前が狭くなってるので中央の見えなくなる所で切って長くします
長くすると言っても数ミリですけどね
Do you call it a tie rod ......
Do you call it a steering gear box (call it a rack and pinion) ......
As it is a little short and the front is narrow, I cut and lengthen it in the place where the center can not be seen
It is a few millimeters to say it will be longer
太めのランナーを切って
Cut a thick runner
穴を開けました(((^_^;)
内径2ミリぐらいのプラパイプ持ってなかったので
こんな感じになります
まだ接着はしてません
ブレーキ回りやタイヤを付けてから
接着します
エンジンのマスキング
ネットで検索した写真では
パイプフレームはシルバーですね
キャリパーは赤に塗る予定です
Caliper will be painted in red
室内ですね
室内はカーボンケブラーだったと思います
カーボンケブラーのデカールを貼るのも大変ですし、ドアも開かないので見えないと思いますので
それっぽい色を塗ろうかと思います
It's indoors
I think the room was carbon Kevlar
It is also difficult to put a carbon kevlar decal, and I don't think the door will open, so I won't see it.
I think I'm going to paint that color
少しは模様替え進んでますね
昨夜の夜にはデスクトップの起動してプリンターやスキャナーを繋ぎソフトのインストを(((^_^;)
本格的なパソコンの配線の処理とかは
ドコモ光の工事とeo光の撤去工事が終わらないと出来ませんけどね(;´∀`)
それまでは完全に片付かないですね(;´∀`)