フジミ 1/24 F355 チャレンジを製作しています
Fujimi 1/24 F355 challenge is being produced
タイヤのパーティングラインを軽く処理
フロントタイヤは段付きしてるので軽く削ったぐらいでは無理なので
Lightly processed tire parting line
Since the front tire is stepped, it is impossible to cut it lightly
足回りは終わりですね
ボディーの合わせ目を処理してますが
細い方は大変ですね
細い金属の板にペーパーを貼り付けてしてますが楽は出来ませんね(゜ロ゜;ノ)ノ
筋彫りも深くしてますが
深くするだけではダメですね
角が丸いのでボディーをもっと削り丸い面を落とさないと
プラの厚みが半分ぐらいになるまで削り筋彫りをすればシャープな感じが出るとは思いますが…………
その前に根本的にボディー形状が違うので
このまま進めますけどね(^_^;)
I've also deepened the carving
It ’s not good just to go deeper.
Since the corners are round, you have to sharpen the body and drop the round surface.
I think it will be sharp if you sharpen and sharpen until the plastic thickness is about half, but ...
Because the body shape is fundamentally different before that
(^ _ ^;)
ランキングに参加しています
ポチッと宜しくお願いします(^-^)v
ポチッと宜しくお願いします(^-^)v
模型・プラモデルランキング