フジミ 1/24 F355 チャレンジを製作しています
Fujimi 1/24 F355 challenge is being produced
久し振りにポリパテを出してみました…………
I tried to put out poly putty after a long time ... ...
次の日の昼…………
まだ硬化してないし(゜ロ゜;ノ)ノ
少し天日干ししてみます(^_^;)
これでも硬化しないと
古くなったポリパテは使えないと言う事ですね(^_^;)
Let's dry some sun (^ _ ^;)
If this still does not cure
You say you can't use an old polypatty (^ _ ^;)
数時間天日干ししてたら少しは固まって来ました
大丈夫かいな?(^_^;)
After a few hours of sun-drying, a little hardened
Are you okay? (^ _ ^;)
ローターのエッチングを取り付けしてますが
少し合いにくいですね
内径が少し誤差が有るかな?
フロントはマシですが
I have the rotor etching
It's a little difficult
Is there a slight error in the inner diameter?
The front is good
リア入りませんね
切れ目を入れてようやくです
接着には瞬間と思いましたが
ローター穴開いてるので
水性クリアーにしました穴が開いてなければ瞬間で付けるのですが………
I don't enter the rear
It ’s finally a break
I thought it was a moment to bond
Because the rotor hole is open
I made it water-based, but if it doesn't have a hole, I'll attach it in a moment ... ……
青島文化教材社(AOSHIMA)
2019-11-28
ランキングに参加しています
ポチッと宜しくお願いします(^-^)v
模型・プラモデルランキング