フジミ 1/16 フェラーリ512BBを製作しています
Fujimi 1/16 Ferrari 512BB is manufactured
塗装の厚みを考慮してもう少し隙間を広めにした方が良さそうですね
It seems better to widen the gap a little more considering the thickness of the paint
高さは中側が低かったので
プラ板をかまして少し上げました
カウルにライトが付く方が楽ですが
実車と同じようになってますね
ヘッドライトの前のレンズ
ランプが無い状態で少し低くなるようにカウルを削ってます(塗装すれば塗装の厚みが有りますので)
Lens in front of headlight
The cowl is shaved so that it is slightly lower without the lamp (because there is a thickness of paint if painted)
ランプを付けて様子見
右側はOKですね
左もOKに見えますが
ランプが少し下がってました
上げるとレンズが浮いてしまいますね
ランプ部を少し下げるのに薄いプラ板をかますかも?
The lamp was down a little
If you raise it, the lens will float.
Do you put a thin plastic plate to lower the lamp part a little?
ランプの中の四角い出っぱり
左右で位置が違うのですが………これで正解?
位置以前に形も合ってる?
The position is different on the left and right ... Is this correct?
Is the shape correct before the position?
ランキングに参加しています
ポチッと宜しくお願いします(^-^)v
ポチッと宜しくお願いします(^-^)v
模型・プラモデルランキング