マクラーレン MP4-12C GT3を製作しています
McLaren MP4-12C GT3 is being produced
ボディーの加工に着手したいと思います
まずはエッチングを取り付けする所から
I would like to start processing the body
From the place where etching is attached first
ここのエッチングは有りませんね
フロントは3ヵ所
後ろは1ヵ所
天井に2ヵ所穴を開ける指定が有りますね
There are designations to open two holes in the ceiling
アンテナが2本付くんですね
アンテナをランナーから外して
差し込み部の太さを計ったりしてたら
ポッキリ折れました(^_^;)))
Disconnect the antenna from the runner
After measuring the thickness of the insertion part
Pokkiri was broken (^ _ ^;)))
長い方はインセクトピンに変更する予定でしたが
予期せず折れたりは精神的に良くないですね(^_^;)))
The longer one was planned to change to insect pin
Unexpected breaking is not mentally good (^ _ ^;)))