フジミ フェラーリ 458 イタリアを製作しています
Fujimi Ferrari 458 I am producing Italy
エンジン上部のパーツ類
まずはサージタンクを先に片づけます
Parts at the top of the engine
First, clean up the surge tank first
フェラーリの刻印をどうやって塗るのか?(;´∀`)
デカールにした方が良かったかな?(;´∀`)
なんとか塗りました
ホースバンド表現にハセガワのミラーフィニッシュを細く切って貼ってます
イグニッションコイルへのハーネス追加してます
I added the harness to the ignition coil
少し見えるかな?ぐらいですね
Does it look a little? It is about
あとタペットカバーのカムシャフト付近に
センサーなのかソレノイドなのか?有ると思いますので
左右配線を2本追加しました
In addition, near the cam shaft of the tappet cover
Is it a sensor or a solenoid? I think that there is
Two left and right wires were added
タペットカバーの取り付けボルト表現でシルバーに点塗りしてますが気付きませんよね
Attaching the tappet cover We are painting points on the silver in bolt expression, but you do not notice